Snapping into your Backbone: 

1 - To snap into your Backbone, insert your phone camera side first to ensure your phone is secured on the left-hand side of the controller. 

2 - Once the left side is secured, use your left hand to hold the phone steady while your right hand extends the Backbone controller to make room for your phone. 

3 - After extending, you should be able to lower the phone into position while lining up the lightning port. 

Removing your Phone:

1 - Start by gripping your phone with your left hand near the lightning connection while holding the right-hand side of the Backbone with your right hand. 

2 - Gently extend your Backbone using these grips to disconnect the charging port connection while keeping your phone flat. 

3 - Once disconnected, use your left hand to tilt the phone up and away from the charging port connector.

Articles in this section

Was this article helpful?
1 out of 1 found this helpful